Use Instructions:
- Preparation: Block off areas to be stripped or finished. Place wet-floor signs around the area to be cleaned.
- Stripping: Use the recommended Diversey brand stripper, following the label instructions.
Coating:
- Apply 2-3 uniform coats using a clean finish mop or the Diversey ProSpeed™/MC or TrailBlazer™/MC Floor Finish Applicator System.
- Apply additional coats until the desired gloss is achieved.
- Allow 30 minutes of drying time between coats. Drying time may vary based on temperature, humidity, and ventilation. Let the finish cure for 24 hours before buffing.
Maintenance:
- Dust mop or sweep the floor.
- Clean the floor with a mop or automatic scrubber using the recommended Diversey brand cleaner, following the label instructions.
- If desired, spray buff using the recommended Diversey floor maintainer to enhance gloss.
Recoating:
- Dust mop or sweep the floor.
- Deep scrub the floor using a Diversey cleaner, following the label directions.
- Block off the area and apply 1-2 uniform coats of finish using a clean mop or the Diversey ProSpeed™/MC or TrailBlazer™/MC Floor Finish Applicator System.
- Let the finish cure for 24 hours before buffing.
Removal:
- Remove the finish using the recommended Diversey brand stripper, following the label instructions.
Best Results:
- Do not dilute the product.
- Do not apply on surfaces colder than 50°F (10°C) with 15% relative humidity.
- To avoid contamination, do not return unused product to the original container.
Note: Floors will become slippery when wet or contaminated with foreign substances. Clean spills and debris promptly. This product meets ASTM D2047 standards for slip resistance.
Reviews
There are no reviews yet.