Diversey Vectra® Floor Finish 5 Gallon

Instructions for Use

Preparation

• Block off areas to be stripped or finished and place wet-floor signs around the area.
• Strip the floor using the recommended Diversey brand stripper as per label instructions.

Coating

• Apply 2-3 even coats using a clean finish mop or the Diversey ProSpeed™/MC or TrailBlazer™/MC Floor Finish Applicator System.
• Continue applying additional coats until the desired level of gloss is achieved.
• Allow 30 minutes for drying between coats. Drying time may vary based on temperature, humidity, and ventilation.
• Let the finish cure for 24 hours before buffing.

Maintenance

• Dust mop or sweep the floor regularly.
• Clean the floor with a mop or an automatic scrubber using the recommended Diversey brand cleaner according to the label instructions.
• If needed, spray buff the floor using the recommended Diversey brand floor maintainer to enhance gloss.

Recoating

• Dust mop or sweep the floor.
• Perform a deep scrub using the Diversey cleaner as per label directions.
• Block off the area and apply 1-2 uniform coats of finish with a clean mop or the Diversey ProSpeed™/MC or TrailBlazer™/MC Floor Finish Applicator System.
• Allow the finish to cure for 24 hours before buffing.

Removal

• Use the recommended Diversey brand stripper as per label instructions to remove the finish.

Best Practices

• Do not dilute the product.
• Avoid using on surfaces below 50˚F (10˚C) at 15% relative humidity.
• To prevent contamination, do not return any unused product to the original container.